Create Liquidity

Overview

"Create Liquidity" helps you add liquidity pools for your tokens on major Solana DEX platforms. Four platforms are supported:

• Meteora DAMM V2 — Meteora's Dynamic Automated Market Maker, suitable for most token pairs
• PumpAMM — The AMM platform in the Pump.fun ecosystem
• Raydium CLMM — Raydium's Concentrated Liquidity Market Maker with custom price ranges
• Orca CLMM (Whirlpools) — Orca's concentrated liquidity pools for efficient market making

You can set the initial price, deposit token amounts, and optionally enable "Stablecoin Mode" for a very narrow price range.

Prerequisites

• Connect Wallet: Click the "Connect Wallet" button in the top-right corner to connect your Solana wallet
• SOL Balance: Ensure you have enough SOL for on-chain fees (at least 0.1 SOL recommended)
• Token Holdings: Make sure you hold the tokens you want to provide as liquidity
• Jito MEV Tip: Configure the Jito MEV tip in settings before sending transactions

Step-by-Step Guide

Step 1: Select Platform

Choose your preferred DEX platform from the "Platform" dropdown at the top of the page:

Step 2: Select Token Pair

• Base Token: Select the primary token for liquidity (usually your issued token)
• Quote Token: Select the paired token (usually SOL, USDC, or other popular tokens)

Click the token selector to search tokens by their Mint address.

Step 3: Configure Pool Parameters

Initial Price

Enter the initial price: how many quote tokens equal 1 base token. This will be the starting trading price after the pool is created.

Base Token Amount

Enter the amount of base tokens to deposit into the pool. The system will automatically calculate the required quote token amount based on the initial price (shown in the "Estimated Quote Token" section).

Stablecoin Mode (Optional)

For Raydium CLMM and Orca CLMM platforms, you can enable "Stablecoin Mode":

• Creates a pool with a very narrow price range
• Keeps the token price within a small fluctuation around the base price
• Only requires depositing base tokens — no quote tokens needed (single-sided liquidity)

Use case: When you want the token price to remain relatively stable with minimal fluctuation around the base price.

Step 4: Create Liquidity

After confirming all parameters, click the "Create Liquidity" button:

1. The system builds the on-chain transaction
2. Your wallet prompts for signature confirmation
3. The transaction is sent to the blockchain
4. A success message appears upon completion

Special Note for Orca CLMM

Orca CLMM uses a two-step process:

1. Create Pool — Click "1. Create Pool" to first create the Whirlpool liquidity pool
2. Open Position — After the pool is created, click "2. Open Position" to open a position and add liquidity

Each step requires a separate signature confirmation.

Important Notes

• Creating a liquidity pool requires on-chain rent and fees — ensure sufficient SOL balance
• The initial price setting directly affects the token's starting trading price — set it carefully
• Base token and quote token cannot be the same token
• When using CLMM (concentrated liquidity) platforms, narrower price ranges provide higher capital efficiency, but liquidity becomes inactive when price moves outside the range
• Stablecoin mode is suitable for token pairs with low price volatility — not recommended for highly volatile tokens
• Ensure Jito MEV tip is configured in settings, otherwise transactions cannot be sent